Clifford SmartWindows 4 Przewodnik Instalacji Pobierz pdf (Strona 9)

7. Set the timer duration to proper time interval with 2-seconds added to that time

interval.

section 2—window rollup

NNOOTTEE::

This may require the use of an optional relay(s).

The instructions in this section apply to systems with the built-in window roll up fea-

ture. If the windows can be closed using a key in the door of the car, see section 1

above.

motor/switch connections

1. Turn the ignition switch to the “ON” position.

2. Access the wires at the window switch.

3. Connect a voltmeter lead to ground.

4. Connect the other voltmeter lead to a wire at the window switch and find the wire

that shows 12V while pressing the window switch as if rolling the windows up.

a. If the voltmeter reads 12V while pressing the “UP” side of the switch, make

the connections as shown in diagram A, otherwise proceed to step 5.

5. Connect the (-) voltmeter lead to +12V and probe the UP wire without activating

the switch.

a. If the voltmeter reads 12V, make the connections as shown in diagram B.

b. If the voltmeter reads 0V, make the connections as shown in diagram C.

NNOOTTEE::

If the vehicle has power window switches only on the center console (no door

switches), you may make the appropriate connections at the console switch. If there

are door switches, it is recommended that you make the connections at each door

window motor.

If the vehicle has relay-driven motors, or one-touch switching, the connections must be

made

aafftteerr

the controlling relay or module.

programming the windows

Use the installer programming section in the security installation manual to program

window roll ups.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Brak uwag

Clifford SmartWindows 4 Przewodnik Instalacji Strona 9